Landig Side Mounted Stainless Steel Chiller Unit

Landig refrigeration units: The advantages in detail

• Energy efficiency at the highest level: Save more than 50% on energy costs compared to previous models thanks to innovative technology and the use of the environmentally friendly refrigerant R290 (propane).
• Evaporator-free interior for maximum use of space: Benefit from significantly more space in the cold room thanks to the evaporator integrated in the housing. For optimal storage of goods and use of the entire room capacity.
• Maintenance-free design for minimal effort: No more frequent maintenance! The Landig refrigeration units are maintenance-free and offer long-term reliability at no additional cost.
• Plug-in solution for easy installation: Thanks to the plug-in design, Landig refrigeration units can be put into operation quickly and easily. The refrigerant is already pre-filled.
• High-quality stainless steel housing for durability: The stainless steel housing guarantees a long service life and optimal hygiene in the cold room.
• Precise temperature control for optimal storage conditions: The electronic temperature control allows the desired temperature to be precisely set between 0°C and +15°C (optionally also -5°C to +15°C).
• Powerful circulating air cooling for even cooling: The LaPlus circulating air cooling system ensures that the cold is evenly distributed throughout the entire cold room, thus guaranteeing optimal storage of your products.
• Fully automatic condensation evaporation: No more annoying defrosting.
• No additional brackets necessary: Thanks to the circumferential seal, the cooling unit can be mounted flush with the cell without the need for additional brackets or installations. Installation is simply done by inserting it into the opening, with the gasket providing a hermetic seal.

Find the right cooling unit

Note on the arrangement of the electronics

This is located on the left side of the unit in the “right” variant, for example “LS 700 right”, and on the right side of the unit in the “left” variant. In the LS 2000 model, the electronics are located on the front of the cooling unit.

Structural requirements for this cooling unit:

• The refrigerator compartment must be insulated all around (min. 8 cm sandwich elements)
• The wall thickness at the point where the unit is to be attached must not exceed 200 mm
• The ceiling, the floor and also the walls must be insulated
• The cold room must have a professional insulated cold room door
• The maximum room volume according to the table must not be exceeded

Note: theperformancespecifications of the refrigeration unit refer to an ambient temperature of +25 °C. At higher ambient temperatures, the performance of the refrigeration unit decreases.